Manual fire alarm buttons are installed in public places, such as on the wall of building walkways, near the service desk on the hotel floor, etc. When the fire is confirmed, press the glass panel on the button to send a fire alarm signal to the controller. After receiving the alarm signal, the controller displays the code or position of the alarm button and sends an alarm sound.
The alarm button adopts modern process SMT technology and built-in microprocessor to detect whether the state of the start button is normal at any time, so as to avoid false alarm caused by the aging of the start switch.
There is a group of passive normally open contacts output during alarm, which can drive audible and visual alarm or other alarm devices at the same time.
The manual alarm button adopts a bright red all plastic structure, which is composed of a base and a button panel. It is simple and convenient to install and disassemble, closely connected, and convenient for engineering commissioning, maintenance and replacement.
After the button is pressed, reset it with a special key. Insert the key according to the lock hole, and rotate it 45 degrees counterclockwise to reset the button.
The fire alarm controller programming terminal or electronic encoder is used for digital coding, which reduces the unreliable factors caused by code dialing error or aging of code dialing switch itself. The digital transmission mode is adopted to improve the anti electromagnetic radiation ability.
