Knowledge

Installation instructions for gas alarm

Oct 25, 2021 Leave a message

1. Installation position of the alarm: within 1.5m from the radius of the air source, it has good ventilation advantages: (1) liquefied gas is heavier than air and is installed about 0.3m from the ground. (2) Natural gas, city gas and carbon monoxide are lighter than air and installed about 0.3m away from the ceiling.


2. Locations where alarms cannot be installed: locations where air is not easy to circulate, such as wall corners and cabinets; Places easily smoked by oil fume, etc.


3. The gas alarm has a wide voltage range. The common products are 220V civil voltage products. Generally, 12V voltage is rare. The power supply mode uses telephone line interface, which is suitable for users with high safety requirements. It is installed in the bedroom. It is small and practical, as shown in Figure 1


Application production and sales the alarm you want in your heart 1. Power light: green light, lights up after power on and goes out when alarm.


Alarm light: red light, on when giving an alarm and off when stopping the alarm.


2. After the power is turned on and the green light is on or flashing for 3 minutes, the alarm starts to work normally.


3. When the detected gas reaches the alarm point, the alarm starts to alarm, the green light goes out, the alarm light lights up, and the buzzer sends out the alarm sound of "B, B, B...". When the concentration of the detected gas drops below the alarm point, the alarm stops. (carbon monoxide alarm with delay function)


4. If the manual detection function is added, when the key is pressed, the green light goes out, the alarm light lights up, and the buzzer gives an alarm sound of "B, B, b...".


5. If the function of combined exhaust fan is added, when the alarm gives an alarm, the connected exhaust fan starts to automatically eliminate harmful gases.


6. If the function of connecting manipulator or solenoid valve is added, when the alarm alarms, the connected manipulator or solenoid valve will automatically close the gas valve, so as to cut off the harmful gas source.


7. If the networking function is added, when the alarm alarms, the management center or control center receives the normally open and normally closed (no, NC) signals at the same time. (if the wireless function is added, the alarm host will receive the wireless signal for 2-3 seconds)


After alarm, a pair of relay passive contact signals (normally open and normally closed can be set by jumper) can be output to control ventilation equipment or provide normally open or normally closed alarm contacts for other equipment.


When the concentration of combustible gas in the environment reaches the set threshold, it can send out audible and visual alarm signals and output relay passive contact signals.


When the concentration of combustible gas in the surrounding environment drops below the response threshold, the detector in the alarm state will automatically return to the normal working state.


Send Inquiry